Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Slide hopper bottom (Item 3) inside cage.
Close the slides on the hopper bottom and rotate the wheel. Adjust hop-
per bottom to ensure there is no binding and all slides close evenly.
7.
CAREFULLY slide hopper top (Item 1) inside the hopper bottom level
and as far as possible, and without disturbing location of hopper bottom.
Tighten cage tightener bolt and nut until the hopper no longer rotates
within the cage. Install 5/16-in. cage tightener jam nut (Items 4)and
tighten to secure.
9.
Install top ring (crossbar with ring; Item 15) on rim of hopper top. Align
crossbar directly above the cage bars with slotted holes. Drill 9/32-in.
holes through rim of hopper top using top ring as a guide. Secure with
1/4 x 1-in. bolts and 1/4-in. hex nuts (Items 16).
11.
Install 5/16-in. flat washer (Item 18C) on bolt, followed by fiberglass cone
(Item 19), another washer (Item 18C) and onto cone support (Item 20).
D
D
NOTE: Thread cone support onto bolt until the end of the bolt is flush with
the bottom of the nut inside cone support. Turn assembly over to verify
bolt is only threaded into nut and not extending into cone support. If it is
extending too far, the completed assembly may be limited to adjustment.
Big Wheel Feeders must be anchored securely to flooring. Order anchor brackets (Item 23) separately. Standard anchor brackets (FF-00RF2E ) are installed
with existing fasteners through existing holes in trough divider cage (three (3) brackets required per feeder). Hook anchor brackets (FF-00RF2F) are installed
anywhere along the lip of the trough divider cage (three (3) brackets required per feeder). Use concrete bolts or slot locks to attach anchors to flooring. Specialty
bolt-and-post anchor kits, fenceline adapters, and water pipe and brackets are also available from Osborne, ordered separately. Follow installation instructions
included with optional accessories. Contact Osborne Customer Service for ordering information.
6.
Slide feed sweep (Item 2) on axle assembly inside hopper bottom. If it
does not touch the hopper bottom, remove it and turn it over.
Raise feed sweep about 1/8-in. and tighten set screw. Rotate the wheel
to ensure the sweep does not rub; adjust as necessary.
8.
Drill 5/16-in. holes through hopper top and bottom using the cage as a
guide. Install 5/16 x 7/8-in. bolts and 5/16-in. nuts (Items 5). DO NOT
OVER-TIGHTEN ON FIBERGLASS.
10. Insert 3/8 x 1-1/2-in. bolt (Item 18A) into round hole at end of cone strap
(Item 17). Place 3/8-in. jam hex nut (Item 18B) on bolt and thread to
expose about 3/4-in. of threads.
12. Tighten 3/8-in. jam hex nut against washer. Do not over-tighten.
Bolt NOT extending
into cone support.
ANCHORING THE FEEDER
Axle
Nut to Tighten
Feed
Sweep
1/8-in.
(3 mm)
gap
Bottom of
Hopper
Publicidad
