Instrument Features - TRAMEX CME 4 Manual De Instrucciones

Concrete Encounter CME4

Instrument Features

Your Concrete Encounter CME 4 employs advanced analog
and digital technology to enable the incorporation of many
new features which greatly extend the capability of the
instrument.
• Two simple push button controls, ON/OFF and HOLD.
• Concrete moisture readings, 0% to 6%, are displayed on a
clear easy to read moving coil meter with linear scale.
• 0-4CM (carbide method) scale for concrete only
• A reference scale of 0 to 100 is also provided.
• To conserve battery life, the instrument automatically
powers OFF after 10 minutes of inactivity.
• Power remains on if a change in meter reading is detected
or any button is pressed.
• An audio alert (bleep) will sound 10 seconds prior to the
meter automatically powering OFF.
• Two LED (light emitting diode) indicators.
• The lower LED illuminates when the ON/OFF button
is pressed and remains on until the CME 4
automatically powers off.
• The upper LED flashes when HOLD is selected.
• If the battery is nearing the end of its useful life, both
LEDs flash sequentially for 3 seconds at each power
ON to indicate that the battery should be replaced.
• HOLD button freezes needle on moving coil meter, to
facilitate ease of recording readings.
• If HOLD was selected prior to the CME 4 automatically
powering off, the frozen meter reading is digitally
memorized and restored next time ON/OFF is selected.
User Guide
5
CME4/0908