GE GPF375 Instrucciones De Instalación página 2

2 REMOVE LOWER ACCESS
PANEL ASSEMBLY
• Remove the two screws below the access
panel. Retain screws.
• Loosen the two screws located between the
door and the access panel. Do not attempt
to remove these screws. They are secured
to the access panel with washers.
• Remove the access panel assembly and
toekick from the dishwasher. Set aside.
NOTE: Do not remove the insulation behind
the access panel or toekick.
Escutcheon Escutcheon
Loosen 2 Screws
Loosen 2 Screws
Access Panel Access Panel
Door Door
Panel Panel
Toekick Toekick
3 MOUNT CUSTOM PANEL TO
METAL SUPPORT PANEL
A
• Lay the custom panel on a flat surface with
appearance side down.
• Measure and mark the center line. Use a
carpenters square to draw the center line.
B
Tabs
Overlap
Bottom
Edge
Tab
• Place the metal door panel support on the
custom panel, with the projecting tabs
overlapping and against the bottom edge.
Center the support panel by matching the
center line to the diamond cutout.
NOTE: Do not remove tape from adhesive
strips.
• Mount custom panel to metal support panel
C
• Remove the custom panel from the support.
• Remove tape from adhesive strips on the
metal support – on the side that touches the
custom panel.
• Carefully, position the metal support onto the
custom panel with center line showing
through the diamond. Press the metal sup-
port against the panel.
2
Metal Support
Overlaps
Top
Edge
Foam
Double Sided
Tape
Remove
Tape Covering
Adhesive Strips