6 Cleaning and maintenance
WARNING
Dangerous mains voltage!
Switch off the shredder and pull out
the mains plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
enter the equipment.
Check that the door switch is working
properly:
WARNING
If the following procedure cannot be
performed, switch off the document
shredder, disconnect the mains plug
and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and open the front
door while the paper is being drawn in.
The cutting unit must turn off immediately
and the "door open" indicator must light up.
• Close the door.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening. The
light barrier must be clear.
• Switch off the machine and then switch back
on.
The cutting unit starts when paper is fed in.
Strip cut only:
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer.
Only use HSM special
lubricating oil for the cutting
unit to do this:
• Spray special cutting apparatus oil through
the paper feed opening along the entire width
on to the cutting rollers.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any pa-
per.
Paper dust and particles are shaken off.
05/2012
All manuals and user guides at all-guides.com
SECURIO P 40
english
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
8 Scope of delivery
• Paper shredder, ready for connection, in car-
ton packing, carton on pallet, tied with strap-
ping tape
• 5 bags for shredded material
• Special cutting block oil (cross cut)
• Operating instructions
Acces so ries
• 10 bags for shredded material,
order No.: 1.442.995.110
• Special cutting block oil 250 ml,
order No.: 1.235.997.403
See page 92 for our customer service address-
es.
17