Famastil 1200W Manual De Instrucciones página 38

Always unplug saw from power supply before any of the following operations.
ADJUSTING THE DEPTH OF CUT
01
The depth of cut should be set ac-
cording to the thickness of the
workpiece.
Loosen the lever to unlock the
02
saw shoe (PIC5).
Move the saw shoe into the desired
03
position. The corresponding depth of
cut can be read from the scale.
04 Tighten the lever to lock the saw shoe
in place.
05 Set depth adjustment of saw such
that one tooth of the blade projects
below the workpiece as shown in PIC 6.
CUTTING ANGLE ADJUSTMENT (PIC 7)
This tool can be set to bevel angles
between 90° and 45°.
01 Loosen the locking knob to unlock
the saw shoe.
02
Move the saw shoe into the desired
position. The corresponding bevel
angle can be read from the scale.
03 Tighten the locking knob to lock the
saw shoe in place.
ATTACHING THE BLADE
To avoid the spindle rotation press the
"spindle lock button" (PIC 8).
01 Loosen and remove the blade
retaining screw by turning the hex
wrench counter- clockwise. Remove the
outer washer.
38
ASSEMBLY / ADJUSTMENT SETUP
WARNING!
PIC 5
PIC 6
PIC 7
PIC 8
Spindle Lock Button