INNO TR121 Instrucciones De Instalación página 2

TR121 Installation Procedure for the individual Vehicle Model
Manufacturer Vehicle model
HONDA CR-V
V
ehicle preparations
Carrier installation locations
Carrier installation locations
Carrier installation cover
Nut plate installation procedure
Nut plate (H01)
Special wrench
Vehicle type
5-door wagon
Cuts
Roof rail
Bolts
Hexagonal nuts
Spring washers
Flat washers
Spacers
Hex wrench
EN-2
Model year
Maximum Load Capacity
140 lbs (64 kg)
2007 - 2011
(loaded items + attachment)
1
Clean the roof, and check the locations to install
carrier on the vehicle.
NOTE
This product must be installed to the specific locations on
the vehicle.
2
Stick a small flathead screwdriver into the cuts of
the carrier installation cover on the vehicle roof rail,
and remove it.
Caution
Be careful not to break the installation cover prongs while
working.
NOTE
Do not misplace the removed covers. Keep them in a safe
place for future use.
NOTE
Carrier installation bolts on the vehicle have high torque due to the
coated paint.
Scrape off the coating by screwing the hexagonal nut a few times.
1
Place the spacers through the installation bolts of the
vehicle.
NOTE
The spacers have been chamfered to allow vehicle body
variability. If the spacers float, adjust them around to prevent
from interference between the nut plate and the installation
portion.
2
Place the nut plate (H01) to the position, and fix it
using the flat washers, spring washers and
hexagonal nuts. Use both the special wrench and
Hex wrench for this procedure.
NOTE
•
The nut plate is symmetric, so that it can be placed
regardless of its right-and-left orientation.
• Tighten the hexagonal nut until the spring washer lies
flat.
• Tighten the hexagonal nut with 5 [N·m] (50 [kgf·cm]) of
torque.
EN
Loading conditions
Bike
3
7009210TR1212B-EN