Fall Hazard Children have suffered serious injuries after falling from changing tables. Falls can happen
quickly.
• STAY within arm's reach of the child.
•ALWAYS secure this unit to the support surface using the screws provided. See instructions.
•Read all instructions before use of the changing top.
•KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE USE.
•Inspect the changing top periodically. Do not use the changing top if it is damaged or broken. Contact
Delta Children's Products with any questions.
•Tighten all loose screws and bolts before each use.
•The maximum recommended weight of the child is 30lbs for the changing table.
•This changing unit must be attached to a level, stable and structurally sound piece of furniture. The surface
must have a minimum width of 35-3/4" and a minimum depth of 17-1/4". These measurements should
include only the flat level surface of the furniture.
•The changing pad used should be 34" x 16" with a maximum thickness of 1".
NOTES ON ASSEMBLY:
-During the assembly process whenever using screws or bolts, check each by placing the screw/bolt on
the diagram of the item which is drawn actual size and design. Be sure to use the proper size and shape
specified in the instructions.
-To assemble this unit you may be required to place the unit on it's side and face. It is strongly
recommended that assembly is done on a soft, non-abrasive surface to avoid damaging the finish.
NOTES ON USE:
Keep children and others safe by following these simple rules:
- Do not allow any child to play on furniture
- Do not allow climbing on any piece of furniture.
- Do not allow hanging from any piece of furniture.
- Always monitor your child's activity when in the nursery.
NOTES ON CARE AND MAINTENANCE:
- Do not scratch or chip the finish.
- Inspect the product periodically, contact Delta Children's Products for replacement parts or
questions.
- Do not store the product or any parts in extreme temperatures and conditions such as a hot
attic or a damp, cold basement. These extremes can cause a loss of structural integrity.
-To preserve the luster of the high quality finish on your product, it is recommended to place a
doily or felt pad under any items you place on the finish.
-Clean with a damp cloth, then a dry cloth to preserve the original luster and beauty of this fine
finish.
-Do not use abrasive chemicals.
-Do not spray cleaners directly onto furniture.
-Lift slightly when moving on carpeting to prevent leg breakage.
-Use of a vaporizer near furniture will cause wood to swell and finish to peel.
4
WARNING