Ty Pennington STYLE 146.46371610 Guía De Uso Y Cuidado página 21

In any case of failure of normal ignition,
please use the lighter (sold separately) to
reach the burner for ignition through the
holes of burner base and thermal baffle on
the bottom of burner diffuser.
WARNING
For your safety:
If at any time you are unable to light
burner and smell gas, wait 5 minutes to
allow gas to dissipate before attempting
to light heater.
Do not touch or move heater for at least
45 minutes after use. Allow emitter and
dome to cool before touching.
CAUTION
Avoid inhaling fumes emitted from the heater's first use. Smoke and odor
from the burning of oils used in manufacturing will appear. Both smoke and
odor will dissipate after approximately 30 minutes. The heater should NOT
produce thick black smoke.
Use of environment
Keep the appliance area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
1.Do not obstruct the flow of combustion and ventilation air.
2. Keep the ventilation opening(s) of the cylinder enclosure free and clear
from debris.
3.Use this appliance in a well-ventilated space only. Do not use it in a
building, garage, or any other enclosed area.
4.Use this appliance in outdoor areas described below:
(a) With walls on all sides, but at least one permanent opening at ground
level and no overhead cover.
(b) Within a partial enclosure that includes overhead cover and no more
than two walls. These walls may be parallel, or at right angles to each other.
(c) Within a partial enclosure that includes overhead cover and no more
than two walls. The following shall apply:
(i) One wall that is equivalent to at least 25% of the total wall area is
completely open.
(ii) 30% or more in total of the remaining wall area is open and unrestricted.
The LP-gas supply cylinder to be used must be:
(a) Constructed and marked in accordance with the Specifications for LP-
gas cylinders of the U.S. Department of Transportation of Dangerous Goods
and Commission, CAN/CSA-B339, as applicable;
21