Simu T5 AUTOSHORT BHz Manual De Instrucciones página 7

If you do not want to use this transmitter as the individual control:
- cut the power supply (2 seconds minimum).
- repeat the opération 4.1* with a new transmitter and then go to step §5.
* In this case, the motor will run for 0,5 second in both directions, that means the limits setting is already done.
5
Programming the first individual control point
This operation can only be performed from the
transmitter that was used for operation 4.1.
- Press the transmitter PROG button for approximately one
second. The motor will run for 0,5 second in one direction
and then in the other.
i
Your transmitter is now programmed to control the motor in stable mode.
6
Programming a new (individual, group or general) control point
6.1- Open the memory of the receiver from the control
transmitter:
- Press the PROG key of the transmitter for about 3 seconds.
The motor will run for 0,5 second in one direction and then
in the other.
6.2- Confirm the operation from the new transmitter you
want to program:
- Press the PROG key of the transmitter for 1 second. The
motor will run for 0,5 second in one direction and then in
the other.
- For group controls, repeat operations 6.1 and 6.2 for each motor in the group.
- For general controls, repeat operations 6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter,
then perform the operation 6.2 with the transmitter to be deleted.
7
Recording / controlling / deleting intermediate position
Recording:
- Move the motor to the wanted
position.
- Press 5 seconds on the "Stop"
key. The motor will run for 0,5
second in one direction and
then in the other.
Deleting: Position the motor on the intermediate position. Press 5 seconds on the "Stop" key, the intermediate
position is deleted.
i It would be only possible to set or control an intermediate position, after the first two consecutive opening
and closing of the shutter (see §7).
8
Modification of the rotation direction (in user mode):
Do not move the roller shutter to the up or down end limit position.
- Press the "Up" and "Down" buttons simultaneously for 5 seconds.
The motor runs briefly in one direction, then in the other.
- Within 2 seconds, press the Stop button for 2 seconds. The motor
briefly runs in one direction, then in the other. The rotation direction
has been changed.
After stage 1, if no operation is carried out before 2 seconds, the motor runs again briefly in one
direction and then in the other, and the rotation direction is not changed.
1
1
Control:
- Press the "Stop"
key for 0,5 second.
The motor runs to the
intermediate position.
5s
1
PROG 1s.
2
PROG ≥ 3s.
2
PROG < 1s.
1
5s
>>
>>
>>
0,5s
2
2s
2s
EN
3/4