PLANT!T aeros iv master Manual De Usuario página 2

assembly instructions
1
Fit the two 13mm Barb to ½" Thread
connector to the holes in the Master Tank
with Level Indicator, and one 13mm Barb
to ¾" Thread connector to each of the
four Planter Tanks, with the barb fitting
and the rubber washer to the outside
– use a spanner or similar to ensure it is
nipped up for watertight seal.
3
Connect the Master Tank to a pair of
Planter Tanks on either side, by fitting
a Master Return Assembly to the barb
fittings on the Thread connectors.
Dipping the end of the tube in a jug of
warm water will make it easier to push
the tube onto the fittings.
For further information and video instructions, visit
1m
www.plantit-growit.com
2
Position the Tanks on a level surface (like
the dots on the 5 side of a die) with the
Planter Tanks thread connectors facing
1m
each other in pairs and the Master Tank
connectors facing these. The assembled
system will require 1m² of floorspace.
4
Fit a length of Silicon Air-line to each
Air-stone. Position one Air-stone
centrally on the base of each Planter
Tank and feed the Air-line out via one
of the grooves on the rim of the Tank
– whichever you use depends on where
you plan to position the Air-Pump.
1m