Publicidad
Idiomas disponibles
Idiomas disponibles
1
Above Counter Installation:
Using the template provided, locate the position of the sink
on the above counter. Provide proper clearance under the
countertop for the faucet supply lines, drain assembly and
the structural parts of the cabinet.
NOTE: If replacing an existing sink be certain to shut off
water supply before removing old sink.
2
Drill a clearance hole inside the perimeter line of the
template for above counter installation.
Perimeter
of
template
Cut opening around the perimeter of the template.
3
Mount the faucet and drain
assembly (not included) on
the sink following the
manufacturer's instructions.
Be certain to apply a bead of
sealing putty on the
underside of the drain (Part
"A") in order to ensure a
watertight seal between the
sink and drain. Remove
excess putty after installing
drain on sink.
4
Above Counter Installation:
• Place the sink temporarily into the template
• Check for alignment and clearance
• Mark the sink and countertop in several places
as a guide for the installation location.
In the United States:
American Standard Brands
1 Centennial Ave
Piscataway, New Jersey 08854
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: (800) 442-1902
www.americanstandard.com
Perimeter of
template
A
In Canada:
LIXIL Canada, ULC
5900 Avebury Rd.
Mississauga, Ontario
Canada L5R 3M3
Toll Free: (800) 387-0369
www.americanstandard.ca
5
After checking fit and alignment, turn sink upside down and
apply a generous portion of silicone adhesive around the
under side of the rim near the edge. Place sink in position.
Wipe off excess adhesive.
6 6
Shut-Off Valves
Connect supply line to faucet (finger tight) and carefully bend
tubes to engage with the supply shut-off valves. Tighten
connections at faucet and shut-off valves for secure seal.
7
Connect trap to drain assembly hand tight to check alignment. It
may be necessary to cut off part of the tailpiece (area "B") or
part of the horizontal leg of the trap (area "C"). Secure joints for
watertight assembly.
2
C
B
In Mexico:
American Standard B&K Mexico
S. de R.L. de C.V.
Via Morelos #330
Col. Santa Clara
Ecatepec 55540 Edo. Mexico
Toll Free: 01-800-839-1200
www.americanstandard.com.mx
7302424-100 Rev 1 6/19
Publicidad
