Installation And Use - Guardian 3-Way SRL Manual De Instrucciones

Installation and Use

1. With compatible carabiner, attach 3-Way SRL to anchor point at or above harness dorsal
D-ring, OR attach to compatible tripod with Mounting Bracket #10983.
2. If being used in combination with Arc-O-Pod or other compatible tripod, completely
assemble/install tripod according to manufacturer's instructions provided with tripod at time of
shipment. TRIPOD MUST HAVE INTEGRAL PULLEY.
3. If being used in combination with tripod, install Mounting Bracket on tripod leg. 1) Place
Mounting Bracket over leg as shown, so 3-Way SRL snap hook will face up towards tripod
pulley; 2) Select desired height of 3-Way SRL on tripod leg, and place Mounting Bracket at
selected location; 3) Install (2) provided Locking Pins through Mounting Bracket and tripod leg
as shown; 4) Secure Locking Pins with connected hitch pins, and ensure Mounting Bracket is fully
secured to tripod leg.
4. Install 3-Way SRL on Mounting Bracket as indicated below.
3-Way SRL
Swivel Eye
attached to
install location
on Mounting
Bracket.
5. To switch 3-Way SRL to rescue/retrieval mode, pull and
hold Winch Locking Pin, then move handle back and forth
until Plunger Pin releases out, and release Winch Locking Pin.
6. To switch 3-Way SRL to standard SRL mode, pull and hold
Winch Locking Pin, then compress Plunger Pin, and release
Winch Locking Pin. Ensure Plunger Pin remains down and
locked in place.
7. To lower cable, rotate Winch Handle counter-clockwise.
To raise cable, rotate Winch Handle clockwise.
8. FOR EMERGENCY USE ONLY. DO NOT USE 3-WAY SRL FOR ROUTINE HOISTING OF PERSONNEL
OR MATERIALS.
Shoulder Bolt
inserted through
Mounting Bracket
and 3-Way SRL,
and secured with
hitch pin.
Locking Pins
inserted through
Mounting Bracket
and tripod leg,
and secured
with hitch pins.
Pull Winch
Locking Pin
Plunger Pin
11