Installation And Use - Guardian 3 Harness Serie Manual De Instrucciones

Installation and Use

All PFAS equipment must be selected and deemed compatible with Series 3 Harness by a Competent
Person. ALWAYS follow all instructions of all equipment used in combination with Series 3 Harness.
NEVER attach connector to any place on harness other than D-ring. Connector gate must be self-closing
and self-locking, and must withstand minimum load of 3,600 lbs. Any excess strap webbing MUST be
stored in harness Webbing Keepers.
To connect Pass-Through Buckle, angle male buckle so it is positioned to
pass up and through female buckle. Fully insert male buckle so that it lies
flat on top of female buckle.
To connect Tongue Buckle, pull webbing strap through framed tongue component,
and insert framed tongue through grommet to secure.
Quick Connect Buckles are activated by engaging two release levers simultaneously to
release the male piece from the female receiver. Adjustments are made by feeding
webbing through the male end using a friction style buckle.
Roller and Friction Adjustments allow the user to make adjustments to Series 3 Harness straps.
Feed webbing through buckle, and slide the buckle down on the strap to tighten, or slide the
buckle up on the strap to loosen.
To adjust dorsal D-ring, slide placard up or down webbing. Dorsal D-ring must rest between the
middle of the shoulder blades.
Dorsal D-ring, chest strap, shoulder straps, and leg straps MUST be fitted for each individual user.
1. Hold at dorsal D-ring, and
fully inspect harness according
to specifications of this instruction
manual. Ensure all straps are not
twisted and all buckles are
unfastened.
5
2. Place harness shoulder straps
over shoulders. Ensure dorsal
D-ring faces out, and is adjusted
to rest between the middle of
the shoulder blades.
3. Connect leg straps around thighs.
Ensure there is no twisting of
webbing. Leg straps should never
dangle or hang loose.