Control Panel Functions; General Cleaning - Guardian Technologies H5450 Instrucciones De Uso Y Cuidado

CONTROL PANEL FUNCTIONS

UV-C ON/OFF Indicator
Refill Indicator
Heat ON/OFF Indicator
UV-C/Warm Mist Control
OFF
1. Night Light
Press the Night Light button to turn
night light on/off.
2. Timer
Press the Timer button to select either
4, 6 or 12 hours. The unit will turn off in
that time.
3. Mist Control
Turn the power/mist control dial to
select mist level.
4. UV-C and Warm Mist Control
UV-C and Warm Mist ON/OFF Button Function:
1st Press: UV-C ON
2nd Press: UV-C & Warm Mist ON
3rd Press: Warm Mist ON
4th Press: Both OFF
E-6
12H
Timer Indicator
6H
4H
Night Light
Timer Button
UV RESET
Mist Control and ON/OFF
5. Water Refill Indicator
When the unit is low on water the Refill
LED on the front panel will light up, and
the unit will shut off. Simply add more
water to continue use. Unit will
automatically resume running when
water tank has been refilled.
6. UV-C Light Replacement Indicator
When the UV-C light needs replacing the
UV-C Replacement LED will light up.
See instructions on page E8 for replacing
the UV-C light and resetting the indicator.
7. Humidity Spout Dual Direction
Broaden mist in two different directions
throughout the room by rotating top section.
CLEANING
1. Always unplug the unit before servicing in any way.
2. The water temperature of the water in the unit after use may be high, allow time for it to cool.

GENERAL CLEANING

3. Inside the base of the unit. Pour excess water out of the unit. Wash out the unit with fresh water
using the cleaning brush and a soft cloth as needed. Do not submerse the base of the unit into
water, or allow water to enter inside the dry air exhaust port of the unit.
4. Water tank. Empty water tank. Remove mist nozzle and clean the mist tube with fresh water.
5. Outer surface of the unit. Wipe the lid and surface of the unit with a soft, damp cloth if needed.
If you notice an accumulation of water during usage, reduce humidity and dry outer surface with a cloth.
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• If you live in a hard water area, we recommend the use of distilled water for your
humidifier. This will help reduce the precipitation of minerals or 'white dust'.
• Do not clean the unit or water tank with detergents or cleaning chemicals of any kind.
ULTRASONIC DISK
1. Unplug unit.
2. Remove the tank and empty all water from unit base and tank.
3. Locate the ultrasonic disk on the inside center of the base unit.
4. Use ONLY the enclosed cleaning brush to gently clean disk and
remove build up and deposits.
Do not scrub or scrape the ultrasonic disk.
Are minerals in your water producing white dust?
Try Decalcification Cartridge FLTDC.
1
Look for cartridge at your local retailer or visit www.guardiantechnologies.com
If scale becomes difficult to remove with brush:
1. Fill the Base with: mixture of 1 tsp. white vinegar and 1 tsp. water.
2. Let solution stand for 5 minutes.
3. With the vinegar in the tank, clean all interior surfaces with a soft cloth or brush to help remove scale.
4. Also check mist nozzle and mist tube in water tank. Clean as needed.
5. Rinse the tank thoroughly with water to remove scale and vinegar solution.
END OF SEASON STORAGE
• Follow the Cleaning and Descaling instructions when the humidifier will be stored at
the end of the season.
• Dry the humidifier completely before storing. DO NOT store with water inside the
Base or Water Tank.
• Pack the unit in its original carton and store in a cool, dry location.
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING
YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE HUMIDIFIER
OR PERSONAL INJURY.
Ultrasonic Disk
(Looking down
into base of unit)
E-7