Troubleshooting Guide - Guardian Technologies H5450 Instrucciones De Uso Y Cuidado

REPLACING THE UV-C BULB
1. Unplug the unit.
2. Remove the tank and empty all water
from the unit base and tank.
3. Flip the base over and locate the
UV-C Bulb Compartment.
4. Remove the two screws using
a philips screw driver.
5. Remove the lid with connected UV-C Bulb.
E-8
6. Twist the light bulb to the left until you can remove it.
7. Replace with new bulb, insert and turn
to the right to secure into place.
8. Replace the lid and secure with two screws.
TROUBLE SHOOTING GUIDE
SOLUTION
PROBLEM
Power Plug: Unplug and then try again.
Water vapor and humidity
are not produced. Power Failure: When the power is returned, try again.
Tank Installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk. (see pg. E-7)
Excessive Water: Remove a certain amount of water from the tank.
Air blows but water vapor
is not produced. Increase mist setting.
Detergent residue and/or oil ingredients from cosmetics may be in tank;
wash out tank and try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
(see pg. E-7) If you use hard water, replace with softer water.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk. (see pg. E-7)
Humidity level is low.
The water in the unit is too cold: Replace with cool, but not cold water.
Damage on the ultrasonic disk: Contact Customer Service
It may take 10-15 minutes before warm humidity is created. The mist
Warm humidity is not produced.
may not feel warm due to the fact it is so fine and is cooled rather
quickly from the air in your home. Test by either feeling the base of the
unit which should be warm to the touch or by allowing the unit to run for
approximately 30 minutes on warm setting in a closed 200 sq. foot room
or smaller. The room should feel moderately warmer if the unit is
working properly.
Poor maintenance or dirty water: Clean the product thoroughly,
The humidity has
and fill it with fresh water.
a bad smell.
Hard water may deposit a certain amount of dust. Dust in the air also
White dust is forming on
settles because of added humidity in the room. Use distilled water if
nearby furniture.
this becomes a nuisance.
* Decalcification Filter (FLTDC) available at www.guardiantechnologies.com
or through Customer Service 1.866.603.5900.
No or low water. Unplug unit and refill tank. Check timer has not been set.
Unit has stopped working.
Check that the safety device triggered. To restart, unplug for 5 sec/replug
Unit shuts off unexpectedly or
then press the power button. Call Customer Service.
does not operate.
Saturation of humidity. Lower mist control setting.
Water is accumulating outside
of unit or area surrounding unit.
Unit not level and water is accumulating. Unplug and place on level
surface. Point spray away from objects. Raise unit on a water-resistant
level surface 2-3 feet off of floor.
Water remaining on bottom of tank. Wipe tank or tilt to drain before
Water dripping when refilling.
transporting.
Make sure tank cap is secured tightly.
Unit must be placed on a flat, level, hard surface.
Increased noise level.
Make sure it is NOT placed on a soft or absorbent surface.
E-9