Essick Air MA0800 Manual De Cuidados Y Uso Del Proprietario página 8

and off to maintain the selected humidity SET point. The fan will turn on if the
"ROOM" reading falls 3% below the SET point and will continue to run the
humidifier until a reading of 1% above the SET point is achieved. The fan will turn
off until the ROOM reading falls 3% below the SET point again.
NOTE: Be sure that the humidistat, which is located on the power cord, is free from
obstruction and away from any hot air source.
Replacement and Care of Filters
WARNING: To reduce the risk of shock
or injury from moving parts, always unplug
humidifier before removing or replacing
any parts.
CAUTION: To help retard bacteria growth
and keep maximum efficiency, the filter
should be replaced at least once per
season, or more often under hard water
conditions. Use Essick/MoistAIR
MAF2 replacement filter.
Replace the evaporative wicking filter at
least once per humidification season or
more depending on water conditions in
your area.
Filter Replacement
1. Unplug humidifier. Before removing
the filter, we recommend moving the
humidifier to an area where floor
coverings are not susceptible to water
damage (i.e. kitchen or bath areas.)
2. Remove the water bottle and set aside.
Be sure not to bump or damage the fill
valve.
3. Grasp the housing assembly and lift
straight up and away from the base
and set aside. The filter is now
accessible.
4. Take note of the filter position.
Remove the filter. You may want to
clean the base at this time. See the
"Cleaning and Maintenance" section
of this manual.
5. Install a new filter (MAF2) into the base. Coil the filter and position it between the
uprights in the bottom of the base. The start and finish of the coil should be
captured at the center of the base (see diagram) and the filter should be resting
on the floor of the base.
6. Return the housing assembly to the top of the base. Reposition the
humidifier to its operating position.
7. The humidifier is now ready to be filledfor operation.
8