Using the trimmer
• Check that the blades are not damaged or deformed before use.
• Apply the oil to the blade before and after each use.
(See page 14.)
• When you finish using the trimmer, turn it off.
• The appliance may not operate in an ambient temperature
approximately 0 °C or lower.
Trimming dry hair
• Use the appropriate attachment as needed. (See page 12.)
1
Slide the power switch on the
main body to the " " position to
turn on the power.
2
Trim.
Trimming wet hair
• Do not use the attachment when trimming wet hair.
1
Wet and apply soap to your body.
2
Slide the power switch on the
main body to the " " position to
turn on the power.
3
Apply less pressure than you
would when trimming dry hair,
and move the trimmer in a gliding
motion.
ER-GK60_EU.indb
13
Cleaning the trimmer
• Clean the trimmer and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Make sure that the trimmer is turned off.
• Remove the trimmer from the AC adaptor.
►With water
Main body, blade and the attachment
To remove light dirt
1. Remove the attachment
and turn the trimmer on.
2. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the trimmer
off.
• Rinse with water and
shake up and down
several times to remove
the water.
To remove heavy dirt
1. Remove the attachment
and blade.
2. Clean the trimmer, the
blade and the attachments
with running water.
• Rinse with water and
shake up and down
several times to remove
the water.
13
2017/04/13
9:18:24