Descargar Imprimir esta página

Gerät Befestigen; Gerät Montieren; Mounting The Appliance; Installing The Appliance - clage CDX 7-U Instrucciones De Instalación

Ocultar thumbs Ver también para CDX 7-U:

Publicidad

6. Installation
Gerät befestigen
140
1. Wasserzuleitungen vor der Installation
gründlich durchspülen, um Schmutz
aus den Leitungen zu entfernen.
2. Gerät an die Wand halten; dann
oben und unten, rechts und links an
den kleinen Aussparungen an der
Gehäusekante die Bohrlinien mar-
kieren (siehe Bild). Optional können
Sie die Montageschablone auf den
heraustrennbaren Innenseiten dieser
Anleitung verwenden.
3. Die Markierungen oben und unten
vertikal miteinander verbinden (A–A).
4. Die Markierungen rechts und links
horizontal miteinander verbinden
(B–B).
5. Die Schnittpunkte dieser Linien sind
die Bohrpunkte.
6. Mit einem 6 mm -Bohrer die Löcher
bohren. Mit gelieferte Dübel und
Schrauben einsetzen. Die Schrauben
müssen 5 mm vorstehen.
7. Gerät in die rückseitigen
Aufhängungs öffnungen einhängen
und sanft herunter drücken bis es ein-
rastet.
Gerät montieren
1. Die Wasseranschlussleitungen an
die Wasseranschlüsse des Gerätes
anschließen. Dazu ⅜"-Dichtungen
verwenden.
2. Das zugehörige Warmwasser-
zapfventil mehrfach öffnen und
schließen bis keine Luft mehr
aus der Leitung austritt und der
Durchlauferhitzer luftfrei ist.
6. Installation

Mounting the appliance

1. Thoroughly rinse the water supply
2. Hold the appliance on the wall, and
3. Connect the top and bottom marks
4. Connect the right and left marks hori-
5. The intersections of these lines are the
6. Drill the holes using a 6 mm drill.
7. Hang up the appliance into the rear

Installing the appliance

1. Attach the water connection pipes
2. Open and close the hot water tap until
9
pipes before installation to remove
soiling from the pipes.
mark the drill lines at top and bottom,
right and left, corresponding to the
small notches at the edge of the appli-
ance hood (see bottom figure). The
alignment template (located on the
pull-out pages in the middle of this
manual) may be used for this purpose
alternatively.
vertically with each other (A–A).
zontally with each other (B–B).
drill points.
Insert the included dowels and screws.
The screws have to protrude 5 mm.
hanging openings until it clicks into
place.
with to the appliance's water connec-
tion. Use the ⅜" seals.
no more air emerges from the pipe
and all air has been eliminated from
the water heater.
CLAGE

Publicidad

loading

Este manual también es adecuado para:

Cdx 11-u