Power Button - Dynex DX-MIDTWER Guia Del Usuario

Opening the chassis
To remove front bezel:
1 Push the two release latches forward.
2 Gently pull the bezel toward you. The front bezel covers the 3.5"
and 5.25" drive bays.
.
Installing the system board
To install the system board:
1 Determine the holes on the system board where the standoffs
need to be inserted. See the system board documentation for the
location of the holes for the standoffs.
2 Install the system board onto the standoffs, then secure the
system board to the chassis with screws from the accessory
package.
Connecting the LEDs, power button, and
reset button
The LEDs, power button, and reset button are located behind the front
bezel. Each component has a wire with a connector that plugs into a pin
on the system board. See the system board documentation to determine
which pins to plug the connectors into.
1 Hard drive LED
2 GND (ground)
3 Power LED
4 Reset button
5

Power button

The following illustration is for reference only. See the system board
documentation for the correct pin locations.
Power LED
Hard drive LED
3
Power button
Reset button