Publicidad
Idiomas disponibles
Idiomas disponibles
1) Charge your unit by plugging the (included) micro-USB end of the connection cable into the back of
the unit and USB-A end of the cable into a computer or powered USB wall adapter (not included).
2) While charging, you should see a red LED shining through the upper-right hand corner of the
speaker grill. When fully charge, the red LED will turn off.
3) To power on unit, slide rocker switch on back from "OFF" to "ON."
4) You should hear a voice announce "Bluetooth Mode" or "Line-in Mode." If not already in Bluetooth
Mode, cycle the Mode ❶button until you hear "Bluetooth Mode." Note that "Line-in mode" is for
when you have a hardwired connection between your source device and the AS313BT.
a. Pairing Bluetooth®
i. When in "Bluetooth Mode" there should be a blue LED flashing quickly (located in
the upper-right-hand corner of the speaker grill). This shows that the unit is in
pairing mode.
ii. On your source device (phone, MP3 player, tablet), start a "search for devices" in
your "Bluetooth" menu. The exact method varies from device to device.
iii. After a few moments, you should see a device labeled "AS313" in the list of found
devices. This is the device you should select.
iv. You should hear a two-tone sound from the speaker if the connection is successful.
At this point the blue LED should be steadily lit (not blinking) as long as your device
is connected.
v. If your device moves out of range, or Bluetooth® is turned off, the speaker will emit
a polyphonic tone and the blue LED will begin to flash rapidly.
vi. Note: Once you have paired to a particular device, you should not have to pair
again, unless the device lost the settings. Upon powering on in the future (or
switching back to Bluetooth from "line-in" mode, you will first hear "Bluetooth
Mode." However, after a few seconds, you should hear a two-tone sound and the
blue LED should light steadily. No further intervention is required.
5) To use the line-in input instead of Bluetooth, press the Mode ❶button briefly. You will hear "Line
in mode" and the blue LED will flash slowly.
Playing Music
1) To play music using a Bluetooth® device, first make sure you have paired your Bluetooth ®
compatible device with the AS313BT portable speaker (see directions above). If not already in
Bluetooth Mode, choose it by cycling the "mode" ❶ button until you hear "Bluetooth Mode."
Then, on your device, begin playing whatever song you like as if you were listeing to it direclty on
your device (or through headphones). The music should play through the AS313BT portable speaker
system.
2) To play music* from a USB flash drive, simply insert the flash drive. You should hear a voice
announce "Play by USB drive." Music will start playing automatically. (See Controlling Music
Playback below for more details.)
AS313BT
Page 4
Publicidad
