Before First Use; Setting The Clock; Preparation Of Coffee - Kalorik USK CM 25282 Manual De Instrucciones

Fax +32 2 359 95 50

BEFORE FIRST USE

When you use your appliance for the first time, pour fresh water
•
into the water tank (without coffee) and switch on the appliance.
Once all the water has passed through, switch off the appliance
•
and let it cool down. When it is cold enough repeat the process 3
times with fresh water.

SETTING THE CLOCK

To set the digital clock, press the PROGRAM button and then press
the HOUR button until the clock displays the desired hour. Press the
MIN button until the clock displays the desired number of minutes.

PREPARATION OF COFFEE

Open the lid of the water tank and pour the desired volume of
•
water in it. The water level can be read off the water level
indicator. Never exceed the maximum level indicated.
Insert filter paper in the filter holder and add the desired quantity
•
of ground coffee using the provided scoop.
Never forget to close the water tank lid before switching on the
•
coffee maker.
Put the jug with closed lid on the hotplate.
•
Plug in the coffee maker. Press the START/STOP button once. The
•
red ON light, will be illuminated, indicating that your appliance is
in use. Thanks to the keep warm function, your coffee stays warm
as long as the appliance is switched on. Note that the appliance
will be switched on as long as you do not switch it off manually.
We advise you not to let the appliance switched on for more
than 2 hours and make sure that you never let an empty jug on
the appliance.
Your coffee maker is equipped with a "Pause-and-Serve"
•
function, which means that when you remove the jug from the
appliance, a non-drip valve will automatically operate to stop
any drops of coffee falling onto the hotplate. When you put the
jug back into place, the non-drip valve opens automatically and
allows remaining coffee to filter through into the jug.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/20
special instruction from Team
Print only
USK CM 25282 - 110127