Kalorik CM 38933 Manual De Instrucciones página 6

Fax +1 305 430 9692
Practical hints: When the water tank is empty, wait a couple minutes longer
before removing the carafe, as some water might still drip out of the filter.
Note: the 2-hour auto-shut off feature is activated when operating the
coffee maker manually, or using the timer.
To shut off your coffee maker manually before the 2-hour auto shut-off
•
period, press the ON/OFF button twice, until both lights and the light of
the LCD display are off.
PROGRAMMING THE COFFEE MAKER (DELAYED TIMER)
To program your coffee maker to brew fresh coffee at a preset time, first
•
follow steps 1 to 4 in the "PREPARATION OF COFFEE" section.
Make sure the coffee maker's clock is set to the right time.
•
Press the PROG button twice (10). The clock will now display 12:00 with
•
the word "TIMER" in the upper left corner. Use the "H" and "M" buttons
to set the desired brew time. Press PROG again to validate the timer
setting.
Press the ON/OFF button (11) twice to activate the preset brew cycle.
•
The green AUTO light (4) will illuminate, when the brew time is properly
set.
When your preset brew time is reached, and the coffee maker starts its
•
brew cycle, the green AUTO light (4) will go out, and the red BREW light
(13) will illuminate, along with the LCD display of the clock (12). The
screen will remain backlit during the whole brewing process.
As with the regular brew cycle, an automatic two-hour keep warm
•
cycle will start after your coffee maker has finished brewing. At the end
of the two hours, the coffee maker will automatically shut itself off.
NOTE: the 2-hour auto-shut off feature will be activated when operating the
coffee maker manually, or using the timer.
To shut off your coffee maker manually before the 2-hour auto shut-off
•
period, press the ON/OFF button twice, until both lights and the light of
the LCD display are off.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
6
Assembly page 6/26
special instruction from Team
Print only
CM 38933 - 120501