Toasting Bread; Care And Maintenance - Russell Hobbs 24200-56 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17

TOASTING BREAD

1.
Sit the toaster upright on a firm, level, heat-resistant surface.
2.
Put the plug into the power socket.
3.
Move the browning control to the required setting (1 = light, 6 = dark).
4.
Put bread into the toasting slot.
5.
Press the lever down fully. It won't lock down unless the toaster is connected to the electricity supply.
6.
The digital display will show the browning setting you have selected (1 to 6) for 5 seconds and then
show the remaining toasting time counting down in seconds. If you change the browning setting
during the toasting cycle, the display will again show the new browning setting for 5 seconds and
then show the remaining toasting time. The toasting time will be adjusted according to the new
browning setting you have selected.
7.
When the time reaches 0 the toast will pop up.
To stop toasting, press 5.
8.
You may raise the lever further, to remove small items.
You may raise the lever during toasting, to check progress, then lower it again.
FROZEN BREAD
1.
Leave the browning control at your favoured setting, insert the frozen bread, lower the lever, then
press the f button.
2.
The f light will come on, and the toasting time will be altered automatically to give the same degree
of browning you get with unfrozen bread.
REHEATING TOAST
1.
Leave the browning control at your favoured setting, insert the bread, lower the lever, then press the
m button.
The m light will come on, and the toast will be given a short burst of heat.
2.
3.
Only reheat plain, "unbuttered" toast.
BUN WARMER
Don't use the bun warmer to warm frozen, buttered, coated, iced, or filled buns.
1.
Raise the bun warmer by moving the bun warmer raising lever downwards.
2.
Sit the buns on top of the bun warmer.
3.
Set the browning level to 1, then lower the lever.
4.
When the lever pops up, remove the warmed buns.
5.
Don't touch the bun warmer wires – they'll be hot.
6.
After use, lower the bun warmer by moving the bun warmer raising lever upwards. Be careful when
using the lever because the upper surfaces of the toaster will become hot during use.

CARE AND MAINTENANCE

1.
Unplug the appliance and let it cool.
2.
Wipe outer surfaces with a damp cloth.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido