Residual Risk; Hazard Generated By Current; Hazard Generated By Human Error; Hazard Generated By Current During Cleaning Work - Praher Plastics EO510IND Manual Del Usuario

6. Residual Risk

Hazard generated by current

6.1.
Manipulation of the EO510IND by operating staff is strictly prohibited and
may only be performed by duly authorized staff, qualified for electrical work.
Compliance with the corresponding instruction and prohibition signs is
required.

Hazard generated by human error

6.2.
The operating staff must be instructed in regard to the residual danger
resulting from electricity and familiarized with correct operation. Efficiency of
the safety training must be verified.

Hazard generated by current during cleaning work

6.3.
Cleaning of the EO510IND may only be performed after disconnection from
power supply (lever switch).

7. General

PRAHER EO510IND controls are significant technical products, which are manufactured with
high accuracy to the most modern technical production methods. Entitled complaints will
naturally be rectified as fast as possible if they occur. The equipment has a warranty after
valid European law. The warranty begins with the purchase date.
ATTENTION! Always rotate valve with manual override upon first installation
or if valve has not been in use for more than 2 months!
ATTENTION! Hand tighten union nuts. Make sure that O-rings are in proper

8. Directions for use

The ball valve with electric actuator EO510IND correspond to the regulations of the following
european standards:
EN60730-1
EN55022
EN60335-1
www.praherplastics.com
position
EN61000-6-3
EN61000-6-2
EN61000-6-1
6
ISO 16135:2006
ISO 9393:2004
ISO 9001:2008