Operation - Olympia G3310 Manual Del Usuario

1. Place the guillotine on a stable, level base with the guillotine side fac-
ing up.
2. The guillotine arm is locked on the cutting unit.
Proceed as follows to unlock the guillotine arm:
− Press the arm lock downwards (Fig. 1/1).
− At the same time, pull the guillotine arm
towards you using the handle (Fig. 1/2).
− Move the guillotine arm upwards
(Fig. 1/3).
3. Adjust the aligning rail to the position you re-
quire (Fig. 2):
− Release the aligning rail's locking mecha-
nism by turning it to OPEN.
− Slide the aligning rail to the position neces-
sary.
− Turn the locking mechanism back to
CLOSE. There are two positions provided:
turn to the right or to the left.
4. Proceed as follows to make a cut:
− Move the guillotine arm upwards.
− Slide the material to be cut under the press-
ing rail and align it to the aligning marks on
the base. Slide it against the aligning rail, if
necessary.
− Press down with one hand on the pressing
rail to clamp the material to be cut
(Fig. 3/1).
− Use the other hand to move the guillotine
arm down and cut the material (Fig. 3/2).

Operation

14
Fig. 1
Fig. 2
Fig. 3