Gaggenau BX 480 611 Manual Del Usuario página 5

Before you begin
Tools and parts needed
▯
Philips head screwdriver
▯
1/8" drill bit and drill
▯
Measuring tape
Parts included
▯
Built-in oven
▯
5 Torx screws
Power Requirements
The outlet must be properly grounded in accordance
with all applicable codes.
Planning notes
Door hinge not interchangeable.
Distance from furniture body to door front 1.85"
(47 mm).
Distance from furniture body to outer edge of door
handle 3.7" (94 mm) after retrofitting the handle (special
accessory).
Pay attention to the front protrusion, possibly including
the door handle, for opening drawers at the sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.
B e f o r e y o u b e g i n
Preparing kitchen units
Kitchen units must be temperature-resistant up to
195° F (90 °C) and adjoining furniture frontages up to
160° F (70 °C).
Ventilation cut-out in the built-in cupboard's
intermediate shelf: at least 0.8 in to 1.65 ft
(20 x 500 mm).
The wall socket must be outside the built-in niche.
Cut recesses on the furniture before inserting the
appliance. Remove any shavings, as these can affect the
operation of electrical components.
Secure unsecured furniture items to the wall using a
commercially available bracket.
Only install the appliance so high that accessories can
be removed with ease.
Dimensions and Cabinet
Requirements
General Cabinet Requirements
Cabinet requirements vary depending on the model to
be installed. Please consult the section
for the details pertaining to your particular model.
All models require:
▯
¼" (6.4 mm) space between the side of the
appliance and an adjacent wall or cabinet door
when installed at the end of a cabinet run.
▯
The cabinet base must be flat and capable of
supporting the weight of your appliance when in
use. See the appropriate weight for your model in
the section pertaining to your
"Dimensions"
particular model.
"Dimensions"
5