Setting The Alarm - Hama TH-200 Instrucciones De Uso

FORECAST
3 UP
MODE
COMFORT LEVEL
HUMIDITY MAX MIN TEMPERATURE
DOWN
4 MAX/MIN
+5.4 +3
+3.6 +2
+1.8 +1
0 0
-1.8 -1
-3.6 -2
-5.4 -3
°F/Hr -12- 6 -3 -2 -1 0H r/°C
5
LIGHT
SNZ
MON TUE WED THUF RI SATS UN
2
1
9
10
G Operating instruction
Controls and Displays
1. Display
2. Temperature trend display (h/°C)
3. MODE button
4. MAX/MIN button
5. SNZ (snooze) button
6
6. UP button (increase set value)
7. DOWN button (decrease set value)
8. LIGHT button (display light)
9. Battery compartment
10. Stand (removable)
7
11. Measurement openings (do not cover)
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please
8
keep these instructions in a safe place for future reference. If you sell the device, please
pass these operating instructions on to the new owner.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to speci c
hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package Contents
• TH-200 LCD thermometer/hygrometer
• 2 AAA battery
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating, and only use it in a dry
environment.
• Do not use the product in the immediate vicinity of heaters or other heat sources or in
direct sunlight.
• Do not operate the product outside the power limits given in the speci cations.
• Do not drop the product and do not expose it to any major shocks.
• Do not attempt to service or repair the product yourself. Leave any and all service
work to quali ed experts.
• Do not modify the product in any way. Doing so voids the warranty.
Warning – Batteries
• When inserting batteries, note the correct polarity (+ and - markings) and insert
the batteries accordingly. Failure to do so could result in the batteries leaking or
11 exploding.
• Only use batteries (or rechargeable batteries) that match the speci ed type.
• Before you insert the batteries, clean the battery contacts and the polar contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries or batteries of a different type or make.
• Remove the batteries from products that are not being used for an extended
period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the environment.
They can contain toxic, environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from the product.
• Avoid storing, charging or using batteries in extreme temperatures.
4. Getting Started
Inserting the battery
• Open the battery compartment (9), insert the battery/batteries, ensuring that
the batteries are inserted correctly in terms of polarity, and then close the battery
compartment (9). The thermometer is now ready for use.
Replacing the batteries
• If the display (1) becomes dimmer, you must replace the battery.
• When inserting the batteries, ensure that the polarity is correct.
5. Operation
• Press the MODE button (3) to switch between the three display modes available. The
modes are as follows (in that order): clock, calendar, alarm.
Note
• The product is usually in clock mode. If the product is in another mode, press the
MODE button (3) until it is in the mode you want.
• When you adjust the settings, the selected item will ash to indicate that it can
be set.
5.1 Setting the time format/time
• In clock mode, press and hold the MODE button (3) for about 4 seconds to start
setting the time:
• Hours
• Minutes
• Press the UP (6) or DOWN (7) buttons to select the individual values.
• Press the MODE button (3) to adopt the set value displayed and skip to the next
item.
• Press the MODE button (3) to save the settings and return to the normal display.
5.2 Setting the calendar
• In calendar mode, press and hold the MODE button (3) for about 4 seconds to
start setting the calendar:
• Year
• Month
• Day
• Press the UP (6) or DOWN (7) buttons to select the individual values.
• Press the MODE button (3) to adopt the set value displayed and skip to the next
item.
• Press the MODE button (3) to save the settings and return to the normal display.
Note
• The weekday is set automatically when setting the date manually.
• If you do not make an entry for several minutes, you automatically exit the setup
mode. The settings that were made up to that point are not saved!
5.3 Switching between the 12/24-hour display formats
Press and hold the UP button (6) for about four seconds to switch between 12-hour and
24-hour time formats, AM or PM appears before the time.

5.4 Setting the alarm

• Repeatedly press the MODE button (3) to enter alarm mode.
• Press and hold the MODE button (3) for about four seconds to start setting the
alarm.
• Hours
• Minutes
• Press the UP (6) or DOWN (7) buttons to select the individual values.
• Press the MODE button (3) to adopt the set value displayed and skip to the next
item.
• Press the MODE button (3) to save the settings and return to the normal display.