Spare Parts/Piezas de repuesto/Pièces de Rechange
21
22
27
Before Assembly
USA
Use of the Toy
Ensure that the toy vehicle is not used until it has been properly assembled and checked by an
adult person.
Always adjust the use of the toy vehicle to the conditions encountered.
This toy vehicle does not possess a continuously effective brake system. Therefore, safeguard the
vehicle against rolling away when parking it. Never park the toy vehicle unattended with a child on
it!
Instruct your child how to use the toy vehicle correctly and draw attention to possible sources of
danger.
Although dangerous situations are unlikely to occur if the ride‐on is used correctly, children at play
should, if possible, be supervised.
Please bear in mind that there is always a danger of children injuring themselves while using
swings, climbing frames, toy vehicles or similar equipment.
When children are at play, situations may arise which cannot be predicted by the manufacturer
and for which he cannot be held responsible.
Before use, always check all screws and plug‐in connections as well as respective safety devices fit
correctly.
Never use corrosive or abrasive substances to clean the ride‐on. Never use substances which may
cause pollution of the environment.
For models with pneumatic tires: Due to the nature of materials used in pneumatic tires, it is not
recommended for the product to be left in any one place for too long where solvents or other
chemicals, i. e. oil, may lie. This may result in a chemical reaction, which could cause the tires to
mark the surface such as a vinyl flooring. If in doubt put something underneath the wheels to
cover the floor. Ensure that air pressure in the tires is correct; if air pressure is too low this in‐
creases wear, and makes riding the balance bike more difficult!
Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every two
or three months.
3