Hama Black Line Instrucciones De Uso página 7

Note – Faulty transfer of measured
values
• In this case, you must resynchronise the stations by
briefly removing the batteries from both stations and
reinserting them.
• If the measured values are not transferred again once
the batteries are inserted, replace the batteries with
new ones.
• If necessary, select a new location for the base station
in order to avoid possible interference in the future.
6.2 Selecting the channel/other measuring stations
Note
• You can install two more measuring stations in
addition to the included measuring station. Ensure
that the base and measuring stations are set to the
same channel.
• Suitable measuring stations can be found at
www.hama.com
• Press the CHANNEL button (D) repeatedly to set the
channel to that set on the respective measuring station.
Channel 1, 2 or 3 is displayed.
• If the symbol is displayed, the weather station will
automatically switch the displayed channel every five
seconds.
6.3 Basic and manual settings
Automatic setting using the DCF signal
• After the first time the base station is switched on
and successful transmission is established between
the base station and the measuring station, the clock
will automatically search for a DCF signal. During the
search, the wireless symbol (11) will flash.
6
Display
Display flashing
Displayed continuously
No display
• If the station still does not receive a signal, press and
hold the button (C) for approx. 3 seconds to start the
manual search for the DCF signal. The wireless symbol
(11) will start to flash.
Note – Time settings
• The search process takes about 7 minutes. If the search
fails, it ends and is repeated at the next clock hour.
• In the meantime you can, however, set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal on a daily basis (between 1:00 a.m. and 5:00
a.m.). If the signal is received successfully, the manually
set time and date are overwritten.
• Press and hold the button (C) again for approximately
3 seconds to stop the manual search.
Note – Summer time
The clock automatically switches to summer time.
DST appears on the display as long as summer time is
activated.
(Manual) settings
• Press the button (C) to switch between display of the
year, date and seconds.
• Press and hold the MODE button (A) for approximately
3 seconds to make the following settings one after
the other:
• Year
• Month and date display
• Month
Searching for the DCF
signal
Active
Successful – signal is being
received
Inactive