Publicidad
Step 5
Carefully turn your ENDS (A and B) over.
å
Turn eight BLACK 9/16" FLAT HEAD SCREWS (32S) into the
å
ENDS (A and B) until the shoulders of the SCREWS rest on the
surfaces of the ENDS.
Slide the END MOLDINGS (L and M) onto the ENDS (A and B)
å
until they are against the LEGS (H2 and I2). Line up the grooves
in the MOLDINGS over the heads of the SCREWS in the ENDS.
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
L
These edges
should be even.
www.sauder.com/services
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
I2
B
M
32S
L
A
H2
Shoulder
414444
M
Page 9
Publicidad
