Installation Preparation; Tools And Materials Required; Remove The Packaging - Monogram 31-10719-3 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TOOLS AND MATERIALS REQUIRED

(NOT SUPPLIED)
Aluminized
duct tape
Pencil and tape measure
Spirit level
Knife
Plumb line

REMOVE THE PACKAGING

CAUTION:
against sharp edges.
CAUTION:
OUT OF THE BOX BY GRASPING THE SIDES.
1. Open hood carton.
2. Remove the liner, foam and cardboard.
3. Remove the tape securing the filters to the insert
sleeve, lift the tabs and remove the filters.

Installation Preparation

Needle-nose pliers
Silicone
Safety glasses
Gloves
Step ladder
Wear gloves to protect
LIFT THE INSERT SLEEVE
1/4" pivoting
1" conduit (for remote
hex socket
Wire nuts
Phillips and flat-blade
Flashlight
screwdrivers
4. Unscrew the 5 nuts securing the damper vent
plate assembly, and remove it from the insert
sleeve. Set the 5 nuts and the damper vent plate
assembly aside, as you will be re-installing it later
in the installation process.
5. Remove the screws attaching the insert sleeve to
the mounting board. Discard the screws.
6. Grasp the insert sleeve by the outside edges, and
lift straight up and out of the carton.
NOTE: Do not lift the insert sleeve by the blower
motor.
7. Remove and properly discard the plastic wrapping.
8. Remove the parts box and other packaging.
11
mounting only)
Electric drill and
3/8" socket/
appropriate bits
nut driver
Tin snips
Wire cutter/stripper
8" ducting and
caps as needed
Strain relief

Publicidad

Tabla de contenido
loading

Tabla de contenido