peerless-AV SC551GL Instalación Y Ensamblaje página 9

For Flat Back Display
Begin with the shortest length screw, hand thread screw through multi-washer and display brackets (B) into
6-1
display as shown. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
For Bump-out or Recessed Back Display
Begin with the longest length screw, hand thread screw through multi-washer, display brackets (B) and spacer
6-2
in that order into display as shown. Screw must make at least three full turns into the mounting hole and fi t snug
into place. Do not over tighten. If screw cannot make three full turns into the display, select a shorter length screw
from the baffl ed fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
DISPLAY
B
DISPLAY
SPACER (HH)
B
9 of 35
MULTI-WASHER (GG)
SCREW
(AA,CC,EE)
MULTI-WASHER (GG)
SCREW
(BB,DD,FF)
ISSUED: 02-25-11 SHEET #: 009-9050-2 05-17-11