Berker 7531 40 07 Instrucciones De Uso página 13

GB GB
Connection Connection
4-channel switching actuator (fig. A), 4-channel C-load switching
actuator (fig. B).
Connection to the bus is by means of the bus connector .
The switching statuses of the relays are indicated by the switch
position indicators . They are used at the same time for manual
operation of the relays independent of the EIB.
A B
Important: Observe that switch status indicators in the C-load actuator
(shown on the right) are inverted for constructional reasons.
The actuators are connected as shown in the schematic.
The actuator outputs can be connected to different phase conductors.