Radio; Cd Player; Radio Reception - Philips AZ 1120 Manual De Instrucciones

RADIO

Radio reception

1. To select the desired waveband, set the source selector to
FM/AM.
2. Tune to a radio station using the tuning knob.
– For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very close
to a transmitter).
– For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by turning
the whole set.
3. Adjust the sound using the VOLUME and DBB controls.
4. To switch off the radio, adjust the source selector to the OFF/
TAPE position (with the cassette keys released).

CD PLAYER

Display indication for CD functions:
– Total track number: in stop mode
– Current track number: during CD play
– Current track number flashes when on PAUSE
– SHUFFLE/ REPEAT modes: when the respective mode is
– PROGRAM: when active: P also appears briefly when you
no: no disc/ error in CD operation or with the CD (see
–
Troubleshooting)
– F: program memory full
Playing a CD
1. Set the source selector to CD.
2. To open the CD door, press OPEN on the CD door.
3. Insert a CD with the printed side facing up and press the CD
door gently close.
– The CD player scans the contents of the CD and the total
number of tracks is shown.
4. Press PLAY•PAUSE 2; on the set/ remote control to start
playback.
5. Adjust the sound using the VOLUME and DBB controls.
6. To interrupt playback press PLAY•PAUSE 2;. To resume,
press PLAY•PAUSE 2; again.
7. To stop CD play, press STOP 9 on the set/ remote control.
8. To switch off the set, adjust the source selector to the OFF/
TAPE position (with the cassette keys released).
Note: CD playback will also stop when:
– you press the CD door open;
– the source selector is in OFF/ TAPE or FM/ AM position;
– the CD has reached the end.
10
activated
store a track
CD PLAYER
CD
PROGRAM
CD