LUND OE Style No Drill Bracket Instrucciones De Instalación página 3

Installation Steps
Insert rivnuts into the three (3) pairs of holes in the
rocker panel. Use a hammer to tap the rivnuts
flush.
3
Using the socket, wrench, and washer
provided, set each rivnut in the rocker panel.
Be sure the washer is on the outside of the
wrench to prevent the head of the bolt from
going through. Repeat step for all rivnuts.
4
x3
(Passenger and Driver Side)
Page 3 of 18
Kit #310040
I-10447
Rev C
Front
Driver's Side Shown
Front
Driver's Side Shown