Orion Cobalt CO104S Manual Del Usuario página 12

Series-Parallel—Two Speakers (dual 4 ohm voice coils)
Note: Verify and ensure that the woofer wiring is connected as shown with the
negative connection from the first woofer coil connected to the positive connection
of the second woofer coil.
Two dual 4 ohm voice coil subwoofers with voice coils in series and then parallel the
two series woofers results in an 4 ohm load to the amplifier
_
+
Figure 8
Figura 8
Abbildung 8
1. Connect each woofer in series by connecting the negative (-) terminal of the first
coil to the positive (+) terminal of the second coil.
2. Wire the positive (+) terminal of each woofer's first coil to the positive (+) terminal
on the amplifier. Wire the negative (-) terminal of each woofer's second coil to the
negative (-) terminal on the amplifier.
10
_
+
_
+
+
_
© 2012 MD Audio Engineering—all rights reserved
_
+