Connectors' Pin Function; Terminals Crimping Instructions; Assembly Procedure - WEG KCS-500 Guía De Montaje

Signal Conectors Kit KCS-500

4 CONNECTORS' PIN FUNCTION

For any information about the pin functions, please refer
to the CVW500 user manual.
5 TERMINALS CRIMPING
INSTRUCTIONS
Wire Sizes / Crimping Tool Recommendations
5.1 mm
Recommended crimping tool: TE 58529-1
The correct wire crimping is shown below:
Wire strand ends must
be visible in this area
Wire strands and insulation shall
0.25 mm max-0.13 mm
min front bellmouth

6 ASSEMBLY PROCEDURE

Before assembling, the wedge lock must be in the open,
or as-shipped, position.
Contact
(partially inserted)
Diaphragm
6 | CVW500
0.5 ... 1.4 mm
both be visible
Wire seal
Mating seal
/ 20 ... 16 AWG
2
Wire barrel shall be closed
at seam with no strands
protruding of showing
Ends of insulation
barrel must be
wrapped around
wire insulation
leaving no sharp
points to damage
rubber wire seal
0.13-0.75 mm
rear bellmouth
0.25 mm max cutoff tab
Retention
fingers
Wedge lock (shown
in open position)