Würth 1952 006 570 Traducción Del Manual De Instrucciones De Servicio Original página 8

DE
GB
INTRODUCTION
FR
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this
ES
manual are closely adhered to.
We guarantee that this product complies with the technical
IT
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
uses other than those described herein.
PT
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PL
Misuse:
DA
- This product should only be used as described in this
documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any
EL
damage caused by the incorrect or unreasonable use of
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
Tool set for pressing in and out of ball joints from the front axle
wishbone.
Mounting with the aid of a pressure frame directly on the vehicle or
at the workplace
Quicker and easy exchange without damaging the admission in the
wishbone.
Instruction: We recommend the Würth Code 1952 006
540) ball joint ejector for pressing out the ball joint stud from
the axle beam
8
METHOD OF PREPARATION
Implementation:
Mercedes Sprinter as of building year 95 (W901-905)
VW LT from 1996 to 2006
VW Crafter & MB Sprinter (W906) as of 2006 as well as
Freightliner Sprinter / Dodge
Dimensions:
A
B
C
D
E
Pushing bush 74 - 62 mm
Pushing bush 74 - 60 mm
Pushing bush 70 - 93 mm
Pushing bush 70 - 48 mm
Pushing bush > 2006+
A B C D E