Care And Maintenance - Allen + Roth F170185-A1 Manual Del Usuario

OPERATING INSTRUCTIONS
CHECKING FOR FLAMES
Observe Flame Height When Lit: The burner will display blue and yellow flames. These flames
should be a blue / yellow color between 1-2 in. height (see Figure 13). These flames should not
be yellow or produce thick smoke. This would indicate an obstruction of airflow through the
burners. The flames should be blue with straight yellow tops.

CARE AND MAINTENANCE

To enjoy the outstanding performance from your fire pit, make sure you perform the following
activities on a regular basis:
1. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2. While cleaning the fire pit, make sure to keep the area around the burner dry at all times. DO
NOT submerge the control valve assembly. If the gas control is submerge in water, DO NOT
use it. It must be replaced.
3. Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean.
Signs of possible blockage include:
(1). Gas odor with extreme yellow tipping of flame.
(2). Fire pit does NOT reach the desired temperature.
(3). Fire pit flame is excessively uneven.
(4). Fire pit makes popping noises.
(5). Spiders and insects can nest in burner or orifice. This dangerous condition can damage
fire pit and render it unsafe for use. Clean burner holes by using a heavy-duty pipe
clearer. Compressed air may help clear away small particles.
4. Carbon deposits may create a fire hazard. Clean burner with warm soapy water if any
carbon deposits develop.
5. Cover your fire pit with an outdoor weather cover when not in use to protect it from the
elements.
NOTE: Always allow fire pit to cool COMPLETELY before you cover the fire pit with an outdoor
weather cover or you attempt the service or maintenance.
Good
Yellow
Light Blue
Blue
Figure 13
Bad
Yellow
Light Blue
Blue
9