SATA 51311 Manual Del Uso página 14

Safe Operation Instructions:
Failure to use or operate in accordance with the instructions listed below will result in electric shock, fire, and/or serious injury.
Among all the warnings listed below, the term "electric tool" refers to a mains-driven（wired）power tool or a battery-
powered（wireless）power tool.Save these instructions.
Workplace:
1 ） Keep workplace clean and bright. Chaotic and dark sites can cause accidents.
2 ） Do not operate the tool in explosive atmospheres, in the presence of flammable liquids, gases, or dust. Sparks from tools can
ignite dust or gas.
3 ） Operate the tool when children and bystanders leave. Do not be distracted.
Electrical Safety:
1 ） The tool plug must match the socket. Never modify the plug in any way. Electric tools to be grounded cannot use any conversion
plug. Unmodified plugs and mating outlets will reduce the risk of electric shock.
2 ） Avoid contact with grounded surfaces, such as pipes, heat sinks, and refrigerators. If your body is grounded it will increase the risk
of electric shock.
3 ） Do not expose power tools to rain or moisture. Water entering the power tool increases the risk of electric shock.
4 ） Do not abuse wires. Never carry wires, pull power tools, or pull out plugs. Keep power tools away from heat, oil, sharp edges, or
moving parts. Damaged or twisted wires increase the risk of electric shock.
5 ） When using the power tool outdoors, use an external wire suitable for outdoor use. Wires suitable for outdoor use will reduce the
risk of electric shock.
6 ） When using the machine in wet conditions is unavoidable, use residual current device（RCD）protection. The use of
residual current devices can reduce the risk of electric shock.
Personal safety:
1 ） Stay alert and pay attention to what you are doing when operating the power tool and stay awake. Do not operate power tools
under fatigue, drugs, alcohol or treatment reactions. Distractions during the operation of power tools can cause serious
personal injury.
2 ） Use safety devices. Always wear goggles. Safety devices, such as dust masks, antiskid safety shoes, helmets, hearing protection,
etc. under appropriate conditions The device can reduce personal injury.
3 ） Avoid sudden start. Make sure the switch is in the off position when plugged into the plug. Inserting the plug with your finger on a
switched-on switch or when the switch is on may cause danger.
4 ） Remove all adjustment keys or wrenches before turning the power tool on. A wrench or key left on a rotating part of a power tool
can cause personal injury.
5 ） Do not stretch your hands too long. Always pay attention to the balance between your feet and your body. This gives good control of
power tools in unexpected situations.
6 ） Dress appropriately. Do not wear loose clothing or accessories. Keep hair, clothing, and sleeves away from moving parts. Loose
clothes, accessories, or long hair may get caught in moving parts.
7 ） If devices are provided for the connection of chip evacuation devices and dust collection devices, make sure they are connected
and used properly. Use these devices to reduce the risk of debris.
8 ） Use clamps or other methods to secure the workpiece to the platform. Holding the machine by hand or leaning the machine against
the body can cause unsteadiness and can cause loss of control.
9 ） Do not use ladders or other unstable support methods. In exceptional circumstances, a firm footing allows the use of better control
machines.
10 ） Keep hands dry, clean and free of grease. Hands with oil may cause loss of control.
14
51311/05155
中文
EN DE RU KO PT JA ES