Special Instructions - Rival DC-TB170 Manual De Instrucciones

only when Blender is not running.
12. Do not use a broke, chipped or cracked Blender Jar.
13. Do not use broken, cracked or loose Cutting Blades.
14. To reduce the risk of injury, never place cutting unit blades
on Base without Jar properly attached.
15. Always operate Blender with cover in place.
16. When blending hot liquids, remove the Filler Cap from
cover. Do not fill Blender container beyond 3-cup level.
Always begin processing at the lowest speed setting. Keep
hands and other exposed skin away from the cover opening
to prevent possible burns.
17. Blade are sharp. Handle carefully.
18. Screw on Blade Assembly firmly. Injury can result if moving
blades become exposed.
19. If the Jar should turn when the motor is switched ON,
switch OFF immediately and tighten Blade Assembly.
20. Do not leave Blender unattended while it is operating.
21. To disconnect cord, turn the control to OFF, then remove
the plug from wall outlet.
22. Never yank the cord to disconnect the appliance from the
outlet. To unplug, grasp plug and pull straight out from the
outlet
23. Use this electric appliance only for its intended use.
SAVE THESE INSTRUCTIONS

SPECIAL INSTRUCTIONS

SHORT POWER SUPPLY CORD INFORMATION
A short power supply cord is provided to reduce the risk of
becoming entangled in or tripping over a long cord. Extension
cords may be used if care is exercised in their use.
If an extension cord is used, the marked electrical rating of the
extension cord should be at least as great as the electrical rating
of the appliance. The cord should be arranged so that it will not
2