Rival DC-TB170 Manual De Instrucciones página 6

HOW TO USE YOUR BLENDER
After unpacking the Blender, wash everything except the
Blender Base in hot, soapy water. Dry thoroughly. Do not place
in dishwasher. Wipe the Blender Base with a damp cloth or
sponge. Do not immerse the Base in water. Care should be
taken when handling the Blades, as they are very sharp.
HOW TO ASSEMBLE AND USE
Important: Your Blender Jar and cutting blades are subject to
wear during normal use. Always inspect cutting blades for
broken, cracked or loose Blades. If Jar or Cutting Blades are
damaged, do not use.
1. Make sure Blender is unplugged. Place Blender Base on
clean, dry surface to keep foreign particles from being pulled
up into motor during operation.
2. Make sure Gasket is in place on outer rim of blade assembly.
The Gasket must lie flat. Screw the Blade Assembly
counterclockwise into the Jar base firmly using the finger
tabs on the bottom of assembly.
3. The Blade Assembly must be screwed into the Jar firmly. If
not, it may loosen when the motor is turned on.
Container
Gasket
Cutting Blade Assembly
4