Parts And Components; Before Use; Cleaning And Maintenance - cecotec BREEZECARE 2000 LIGHT Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.
1. Light indicator
2. Humidification power knob
3. LED light button
4. Cover

2. BEFORE USE

Take the product out of the box.
Remove all packaging material and save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
3. OPERATION
Note: The ideal relative humidity level for human comfort is between 45 % and 65 %. Excess
humidity shows up in the form of condensation on cold surfaces or cold walls in the room. To
measure the room's humidity correctly, use a hygrometer.
Relative humidity in different environments suitable for people:
Bedroom, living room: 45-65 % RH
Patient's room: 40-55 % RH
Room with computer, experiment equipment: 45-60 % RH
Room with piano: 40-60 % RH
Museum, exhibition hall, and library: 40-50 % RH
Place the device on a flat surface.
Remove the cover and fill in the water tank. Do not exceed the maximum level mark on the
tank. Replace the cover.
Turn the humidification power knob to select the desired humidification power level. The light
indicator will turn on.
Note: When the water tank is empty or there is not enough water, the red light indicator will
turn on.
When the device is turned on, press the LED light button to turn on the product's light.
If the device is not going to be used for some time, empty the tank. To do so, take the cover off,
tilt the product (tank and base together) and pour all the water out.
Fig. 2.
32 BREEZECARE 2000 LIGHT
Warning: Do not exceed the maximum water level mark when adding water: 1.2L.

4. CLEANING AND MAINTENANCE

Use a soft, damp cloth to clean the surface of the device.
Do not use detergent, scouring pads, chemically treated cloths, gasoline, benzene, alcohol,
thinner, or other solvents, as these can scratch and damage the tank and cause water leakage.
Do not immerse the product in water or any other liquid.
If scale is built up due to the use of hard water, it is recommended to:
Use cold boiled water or distilled water.
Change the water in water tank more often to keep it fresh.
Make sure to pour out water from the water tank and dry the water basin before you store it
unused for a long time.
Clean the whole humidifier and make sure that all parts of the humidifier are dried completely
if it is supposed to be leaved unused for a long time.
5. TROUBLESHOOTING
Trouble Possible cause
The humidifier is not plugged
in.
The light indicator is off
Power cord is damaged.
when switched on
Humidifier is defective or
malfunctioning.
Humidifier is not turned on.
The light indicators is on
when switched on, but no
The set humidification level is
mist comes out
too low
ENGLISH
Solution
Plug the humidifier into a
powered electrical socket.
Stop using the device
immediately and contact
the Technical Support
Service of Cecotec.
Turn the knob to the ON
position.
Increase the humidity
level.
BREEZECARE 2000 LIGHT 33