General Maintenance; Cutting Blade - Blaupunkt GX 1000 Manual Del Usuario

MAINTENANCE
SAFETY
Before any inspection, maintenance or cleaning of the mower is conducted.
1. Ensure that the cutting blade has fully stopped rotating.
2. The mower is disconnected from the mains power supply.
BEORE EACH USE
NOTE: Care should be taken when turning the mower unit for inspection or cleaning.
1. Remove any grass and debris from around the cutting height adjustment lever, the air filter in the cowl and the underside of
the mower deck.
2. Ensure the grass collection bag is empty, and inspect for signs of damage.
3. Check the condition of the rear deflector, along with the mower deck.
4. Inspect the condition of the cutting blade - note: wear strong gloves when working with or around the cutting blade.
5. Ensure that the cutting blade is not bent or cracked.
6. Check the condition of the blade and it's mountings.
7. Check that the fixing bolt is secure.
8. Check the power supply cable.
9. Inspect the 'Switch control & safety button' .
10. Check that all securing nuts and bolts are tight.
!
WARNING: If signs of damage are found, the mower unit should not be used until fully repaired by a qualified person.
LUBRICATE THE WHEELS, PIVOT POINTS AND LINKAGES AFTER 25 HOURS OF USE
REPLACE THE CUTTING BLADE AFTER 50 HOURS OF USE

GENERAL MAINTENANCE

1. Remove all grass debris from the top and underside of the mower deck, as well as from around the ventilation holes, immedi-
ately after use - note: wear strong gloves when working with or around the cutting blade.
2. Motor unit - this motor unit is maintenance free and should not be accessed by anyone other than an approved maintenance
engineer.
3. Switch control & safety button - is maintenance free and should not be accessed by anyone other than a approved
maintenance engineer.

CUTTING BLADE

1. The cutting blade has sharp edges, always wear strong gloves to protect your hands when working with or around the cutting
blade.
2. Always work away from the cutting edges of the blade to avoid the risk of injury.
3. Care should be taken when turning or lifting the mower unit.
4. It is recommended that the cutting blade is replaced every two years or after 50 hours operation, which ever occure the
sooner.
5. Damaged or worn blades should by replaced immediately.
BLADE REPLACEMENT (Fig. 7)