Eaton E5524E0402 Instrucciones De Puesta En Servicio página 3

4.1 Polarity of the inputs
4.2 Switching on the 30 Hz filter (INP A)
4.3 Multiplying factor (totalizer)
4.4 Dividing factor ( totalizer)
4.5 Decimal point (totalizer)
* where bounce occurs, e.g. with contacts
MN05401010E
npn: sinking sensor
pnp: sourcing sensor
The filter provides input
damping*
30 Hz filter off (f max )
30 Hz filter on
It can be set from 00.0001
up to 99.9999.
"0" is not accepted!
It can be set from 00.0001
up to 99.9999.
"0" is not accepted!
The decimal point defines
the way of displaying the
count values. It does not
affect counting.
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
4.6 RESET mode (totalizer)
4.7 Multiplying factor (frequency meter)
4.8 Dividing factor (frequency meter)
4.9 Decimal point (frequency meter)
manual reset via the red
RESET key and electrical
reset via the RESET input
no reset (red RESET key
and RESET input locked)
only electrical reset via the
RESET input
only manual reset via the
red RESET key
It can be set from 00.0001
up to 99.9999.
"0" is not accepted!
It can be set from 00.0001
up to 99.9999.
"0" is not accepted!
The decimal point defines
the resolution in the select-
ed measuring range 1/min
or 1/sec
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
3