Samsung DV457* Información Técnica página 11

TROUBLE SHOOTING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
COMPONENT TESTING PROCEDURES
Component Electrical Testing (with ohmmeter)
Thermistor resistance 10K Ω @ 25°C 77°F

Thermostat 1 resistance < 1Ω

Thermostat 3 resistance < 1Ω

- If resistance is infinity, replace thermostat 3.
Thermostat 2 resistance < 1Ω

- If resistance is infinity, replace thermostat 2.
Heater resistance 10 Ω

- If resistance is infinity, replace Heater.
Measure resistance of the following terminal

1) Door switch : off
Terminal : "COM" - "NC" (1-3) < 1Ω
Terminal : "COM" - "NO" (1-2) : ∞ Ω
2) Door switch : On
Terminal : "COM" - "NC" (1-3) : ∞ Ω
Terminal : "COM" - "NO" (1-2) < 1Ω
Technical_information-02835D-02_EN.indd 11
WARNING
Belt Cut-off S/W

- Lever open: Resistance value < 1Ω
- Lever push: Resistance value : ∞ Ω
Lamp resistance 80~100 Ω (Violet & gray)

Motor (Electronic & GAS)

Function 1M
Start
Run
 = Contact closed
Centrifugal Switch (Motor)
11
Contacts
2M 3M 5M 6M
2.88Ω between
Pin# 3 and 4
3.5Ω between
Pin# 4 and 5
2012-04-26 11:51:33