Mopar 4280189 Manual Del Usuario página 10

10
45. Reinstall the center trim/radio bezel.
46. Reinstall the instrument cluster trim.
47. Install the screws that secure the instrument panel
steering column cover reinforcement (1) to the
bracket. Tighten the screws securely.
48. Connect the trunk release switch and install the lower
instrument panel cover (2).
49. Install and tighten the screw securing the lower instru­
ment panel cover near the hood latch switch.
50. Install and tighten the screw securing the lower instru­
ment panel cover to the left side door opening.
51. Install the trim panel located on the left side door open­
ing.
PROGRAMMING THE WIN
CAUTION: Read all notes and cautions for programming procedures.
NOTE: Have the vehicle PIN readily available before running the routine
CAUTION: If the PCM and WIN are replaced at the same time, the PCM MUST be programmed before the WIN.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "WIRELESS CONTROL MODULE (WCM)"
• Select the "MISCELLANEOUS FUNCTIONS" tab
• Highlight "WIN REPLACED"
• Select the "Start Misc Function" button
• Select "NEXT"
• Enter the PIN when prompted.
• Select "NEXT"
• Verify that the PIN number is correct
• Once verified select "NEXT"
• Select "NEXT"
• Note On­Screen instructions and select the "FINISH" button
Dec 01, 2009
4280189
K6860933