Descargar Imprimir esta página

Mopar 4280189 Manual Del Usuario página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Disconnect and isolate the negative battery cable.
2. Open the hood.
3. Locate the opening (1) designated for the hood ajar
switch on the brace near the rear passenger side of
the engine compartment.
4. Route the hood switch harness (1) underneath the
brace and through the opening designated for the
hood switch.
5. Connect the hood switch (2) to the hood switch har­
ness (1).
6. Once connected, insert the hood switch (2) into the
opening, turn the hood switch (2) until properly seated.
7. Route the hood switch harness (2) into the engine
compartment.
8. Locate the factory ground lug (1) on the passenger
wheel well/shock tower. Remove the nut.
9. Install the hood switch ground terminal onto the fac­
tory ground lug and reinstall the nut.
10. Secure the hood switch harness (2) to the vehicle har­
ness using the tie straps supplied in the kit.
Dec 01, 2009
4280189
3
K6860933

Publicidad

loading