Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
27 to 39 inches (686mm to 990mm) (FIG. t).
Lower sash must open sufficiently to allow a clear
vertical opening of 16 inches (406mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal, The rear of the unit
must be outdoors, not inside a building or garage.
L _
-Sas,
27, ,o 39,,d !
/
':, .
|1
_
Window
[ 1161 m,n. innersillLl_
Offset
Interior wa_ll"'4
. _,"
FIG. 1
ELECTRICAL
SERVICE
Check your available electrical service, The power
supply available must be the same as that shown
on the unit nameplate (found on right side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections.
SAVE CARTON and this OWNER'S MANUAL for
future reference. The carton is the best way to store
unit during winter or when not in use.
INSTALLATION HARDWARE
FIG. 2
ITEM
A
B
C
D
E
F
--G
H
I
--j
NAME OF PARTS
Q'TY
SIDE CURTAIN
2
SILL SUPPORT
2
BOLT
2
LOCK NUT
2
SCREW: 25/64"
13
SCREW: 5/8" -
3
SCREW: 5/8"
5
FOAM SEAL
1
FOAM STRIP
1
L BRACKET
1
To avoid risk of personal in ury, property damage,
or product damage due to the we ght of th s
device and sharp edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent in ury or strain, use proper lifting and
carrying techniques when moving unit.
• Carefully inspect location where air conditioner
will be installed. Be sure it will support the
weight of the unit over an extended period of
time.
• Handle air conditioner with care. Wear
protective gloves whenever lifting or carrying the
unit. AVOID the sharp metal fins of front and
rear coils.
• Make sure air conditioner does not fall during
installation.
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end wrench or adjustable wrench
• 1/4-inch hax socket and ratchet
• Tape measure
• Electric drill
• t/4-inch drill bit
-5-
Publicidad
Capítulos
Tabla de contenido
