Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Pick a location which will allow you to blow the cold air
into the area you want. Windows used for installation
must be strong enough to support the weight of the air
conditioner. Good installation with special attention to
the proper position of the unit will lessen the chance
that service will be needed.
When cooling more than one room, installationlocation
is very important. If air conditioner is blocked by a storm
window frame, see step 19 on page 8 before beginning
to install. To cool a room, cold air must be blown from
the air conditioner in a straight path into the room.
HOW TO INSTALL
_1
Remove the screws which fasten the cabinet at
both sides and at the back. Save side screws.
Discard back screws.
B
Slide the unit out of the cabinet by gripping the
base pan handle with one hand, and pulling it
forward while bracing the cabinet with your other
hand.
FIG. 4
I_Jl Cut the FOAM STRIP (ITEM I) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown in Fig. 5.
L_
Insert the side curtain (ITEM A) into the upper
guide and lower guide of the air conditioner. Fasten
the curtains to the unit with screws (ITEM E).
FIG, 6
I_'_ Open the window. Mark a line on center of the
window inner sill. Carefully place the cabinet on the
window inner sill and align the center of the cabinet
front with the center line marked on the window
inner sill.
Window inner sill
FIG. 7
r_
Pull the bottom window sash down behind the
upper guide until the sash rests on the cabinet top.
NOTE: Do not pull the window sash down so tightly
that the movement of side curtain is restricted.
Windowsash
Cabinet
S_
Curtain
_rguide
FIG. 8
_'_ Loosely assemble the sill supports using the
parts in FIG. 9.
FIG. 5
INDOOR _
_
OUTDOOR
--
_
I
MB
C_
_"
_ITEM D
ITEM
FIG. 9
-6-
Publicidad
Capítulos
Tabla de contenido
